DOT Approved
3 Pole (3 Pin)
All electronic (Solid State, not mechanical)
Mounting adapter, wire harness and ground wire included
Works on both LED and regular filament bulb turn signals
When converting incandescent turn signal bulbs into LEDs, the "flash rate may be too fast. A common solution is to purchase and install two or more load equalizers. However, load equalizers may produce dangerous heat and they use just as much power as the original incandescent bulbs. This fully solid-state relay uses advanced electronic technology to adjust the flash rate of ANY LED turn signal to a standard 60 per minute flash rate and NO HEAT is generated. It uses virtually no power and is plug-n-play compatible with any motorcycle. Technical Specifications - Maximum operation amperage: 15A - Minimum operation amperage: 0.1A.

Faulty flasher relays are usually easy to spot by their common failure modes. The flashers will usually stop flashing and the turn signal indicator in the instrument cluster says illuminated. When converting incandescent turn signal bulbs into LEDs, the "flash rate may be too fast. A common solution is to purchase and install two or more load equalizers. However, load equalizers may produce dangerous heat and they use just as much power as the original incandescent bulbs. This fully solid-state relay uses advanced electronic technology to adjust the flash rate of ANY LED turn signal to a standard 60 per minute flash rate and NO HEAT is generated. It uses virtually no power and is plug-n-play compatible with any motorcycle. Technical Specifications - Maximum operation amperage: 15A - Minimum operation amperage: 0.1A.